Pass with professional 300-110 actual quiz materials

Cisco 300-110 Exam Overview:

Cisco 300-110 Exam Syllabus Topics:

Cisco Designing Cisco Wireless Networks Sample Questions:

1. A consulting engineer for a copper mine is trying to extend the network connectivity of autonomous trucks via Cisco IW3702 APs. The WGB design requirements include: latency- sensitive application (truck slows at 10 sec, stops at 20 sec of connection loss), aggressive scanning and roaming, enterprise-grade security without certificates on each AP, multiple clients in different VLANs on the WGB, and channel scan parameters restricted to only channels in the truck path. Which design approach meets the requirements?

A) WGB in static mode with EAP Fast connected to a dot1q-capable switch
B) WGB in static mode with EAP-TLS connected to a dot1q-capable switch
C) WGB in mobile station mode with EAP-TLS connected to a dot1q-capable switch
D) WGB in mobile station mode with EAP Fast connected to a dot1q-capable switch

2. A customer has a centralized wireless deployment with N+1 high availability and few open authentication SSIDs configured. After failover, all APs are broadcasting all SSIDs, but the clients are assigned IP addresses from a different subnet. The WLANs on both WLCs are configured with the same dynamic interfaces. Which feature must be incorporated in the wireless design of the second controller?

A) VLAN Select
B) AAA Override
C) AP Groups
D) RF Protocol

3. A customer is planning to replace older access points with Cisco 4800 Series Access Points.
Unaware of the infrastructure requirements, the client has an engineer investigate the inline power requirement. Which IEEE 802.3 standard complies with the Cisco 4800 Series Access Points?

A) 802.3af
B) 802.3at
C) 802.3ac
D) 802.3bt

4. A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)

A) absorption
B) client authorization
C) access point height
D) wireless channels
E) client authentication

5. A school deploys a Cisco wireless infrastructure in its classrooms to support a high density of mobile devices. The network administrator wants to bond channels in groups of two and only allow APs to send 802.11 management frames at 24 Mbps. What should be included in the design to accomplish this objective?

A) Set the channel width for 802.11a to 40 MHz and set data rates to 24 Mbps and Mandatory.
B) Set the channel width for 802.11b to 40 MHz and set data rates to 24 Mbps and Mandatory.
C) Set the channel width for 802.11b to 40 MHz and set data rates to 24 Mbps and Supported.
D) Set the channel width for 802.11a to 40 MHz and set data rates to 24 Mbps and Supported.

Solutions: